The Rack Savage is a 3D-printed skull mount built to white-tailed deer proportions, with the pedicle spread and angle that make a whitetail rack read as a whitetail on the wall.
Most whitetail sheds end up in a garage or a box in the closet. Not because they aren't worth showing, but because the options were bad: boil a real skull, pay a taxidermist a few hundred dollars, or glue the antlers to something and hope it holds. The Rack Savage is a fourth option.
HOW THE BULLET LOCK WORKS
Two Bullet Lock connectors thread directly into the base of each antler. Interlocking gear teeth inside the skull's sockets let you rotate each antler independently and lock it at the angle you want. No glue, no permanent commitment, no guessing whether it's straight before adhesive sets. If the symmetry isn't right, back it out and reset it.
Because the connectors screw into the antler itself, the system works the same for a naturally shed antler and one cut from a harvested buck.
WHAT'S INCLUDED
- 1x Rack Savage whitetail skull mount
- 2x Bullet Lock connectors
- 2x #10 x 1.5" mounting screws
- 2x 6M locking washers
- Installation guide card
WHAT YOU'LL NEED
A saw to cut the antler bases flush, a drill with a 1/8" bit, and a driver. Plan on about 30 minutes start to finish. Full step-by-step instructions are in the installation guide.
ABOUT WHITETAIL SHEDS
Whitetails drop their antlers between January and March depending on latitude, nutrition, and how hard they ran the rut. A buck that peaked in November often sheds earlier than one that came through the season easy. The matched set you picked up in February has a story behind it, and that's worth more than a generic display.
COMPARED TO A TAXIDERMIST EURO MOUNT
A traditional euro mount means boiling or beetling a real skull, degreasing, whitening, and mounting it. Done professionally that runs $200 to $300 and takes weeks. The Rack Savage is $69.99, ships in 24 hours, and works with sheds, which matters when you don't have the skull at all.
